380V 50HZ Cigarette Reclaimer Three-phase Four Wire System
Paper and Tobacco Thread Split Machine
This paper and tobacco thread split machine has the advantages of
concise and nice structure, energy-saving, easy-operating, high
threshing performance rate, no tobacco paper tows during the
recovery of tobacco threads, little smashing of the tobacco
threads, and high production rate .The residual tobacco threads
treated by this machine can be used to re-produce cigarettes
without any other processing. This machine plays an important role
in reducing tobacco consumption in cigarette-making factories, and
in increasing economic profit for the factories.
This machine adopts the three-phase four-wire system, 3N-380V/220V,
50HZ.The power is plugged through the X1 cable connector couple of
the provided main motor. The gross power for the power supply
configuration is 3KVA.
- Exterior Size: Cutting System(L×W×H): 2200×680×1000mm; Split
- Production Rate:20-25kg/h
- Recovery Rate of Tobacco Threads:﹥93%
- Conversion Rate for Whole Tobacco Threads: ﹥85%
- Impurity Percentage:﹤1.7%
- Power Supply:380V 50HZ
- Gross Power for Motor
Electrical Driving Force
4.1.The provided power for M1 main transmission reduction box
Y2-801-4 is 0.55KW, 1390r/min, reduction transmission proportion is
1:9.It is used to drive the tobacco cutting part and elevator belt.
4.2 The power for M2 cutting knife motor Y801-2 is 0.75 KW, 2825
r/min. It is used to cut off waste cigarette and bring to the
vibrating screen split system by main dragging belt.
4.3 The power for M3 vibrating screen Y100L-6 is 1.5KW, with 940
r/min. It will drive the vibrating screen to split the tobacco
threads from shredded paper and filter tip.
- The above motors use F1, F2 and F3 motor breakers accordingly, with
over-load and over-current protection.
- The motor M1 for main transmission reduction box is controlled by
relay K1 , and it is manipulated by button switches S1 and S3 to
enable and stop; Cutting knife Motor M2 and vibrating screen motor
M3 are controlled by relays K2 and K3 separately, with button
switches S2and S4 to enable and stop.
5.1 Switch to enable power Q1.
5.2 Enable relays F1and F2 when start the machine for the first
time: but no need and start again later, except for the breakdown
5.3 Enable button switches S1 and S3 , the horizontal conveying
belt and the vibrating screen in the cutting part will start to
5.4 In case of emergency, press S2 and S4, the main motor and the
vibrating screen in the cutting part will stop running .After
troubleshooting press S1 and S3 again to restart the machine.
- This machine can only be operated by 2 people .When cutting knife
protection shield is open, the operation to press the “enable”
button is forbidden.
- No metal objects in the residual cigarettes that are to be put in
- Operation and Maintenance
This machine needs following inspection and maintenance after
running for one week:
- Clean dust and impurities inside the machine.
- Check the lubricating oil quantity and quality in the speed
- Check the tightness of the synchronous belt adjust in time.
- Check the wear and tear for the knives, change in time if needed.
F1, F2 and F3 Motor , 380V 50HZ Machine Cigarette Reclaimer